5
Lit. No. 62639
October 5, 2001
INSTALLATION INSTRUCTIONS
Centerpunch
Holes
Figure 8
Notched
Edge to
Inside
Bent Side of
Bolting Bar Forward
5/16" X 1"
Bolt and
Nut
Driver-Side
Deflector
Figure 9
5/16" x 1"
Bolt and Nut
Figure 10
CENTER DEFLECTOR (Continued)
4.
Using the four holes on the center deflector,
centerpunch holes in the A-frame.
(See Figure 8.)
5.
Remove the center deflector and drill four 3/8" holes
in the centerpunched locations.
NOTE: Do not attach center deflector at this
time.
RUBBER DEFLECTOR
1.
Align the holes in the bolting bar, rubber deflector,
and the top curl of the blade. The notched edge of
the rubber deflector goes towards the inside. The
rubber deflector with the WESTERN
®
logo goes on
the driver side. The bent side of the bolting bar
goes towards the front.
(See Figure 9.)
2.
Insert a 5/16" x 1" bolt into each hole and attach a
nut to each bolt.
(See Figure 9.)
3.
Install the center deflector using holes drilled in
Step 5 of Center Deflector installation instructions,
four 5/16" x 1" bolts, eight 5/16" flat washers, and
locknuts.
When installed, bolt heads should be on the inside
of the A-frame and nuts should be visible on the
outside of the A-frame.
(See Figure 10.)
