Western MVP, Installation Instructions Manual

Page: 19 / 24

15
Lit. No. 62639 October 5, 2001
INSTALLATION INSTRUCTIONS
Wire Color Pin No.
Light Blue With Orange Stripe 1
Blue With Orange Stripe 2
Black With White Stripe 3
Light Green 4
Light Blue 5
White With Yellow Stripe 6
Brown With Red Stripe 7
Red 8
Orange With Black Stripe 9
Brown With Green Stripe 10
Table 1
Insert pins from this side
Figure 30
CAUTION
Do not alter, modify, or install additional
components in shaded areas of Figure 29.
Failure to comply may cause damage to the
product or property.
VEHICLE HARNESS AND VEHICLE
CABLE INSTALLATION
(Continued)
20. Locate a connector bracket mounting position under
the dash where it will not interfere with other
equipment. Mount the connector bracket using #8 x
5/8" tapping screws and washers.
Figure 29
21. Feed the vehicle harness through the bracket.
22. Insert each of the 10 socket-type terminals into the
connector housing. (See Figure 30.)
Refer to the Table 1 for under-dash vehicle harness
connector pin assignments.
NOTE: A “snap” will be felt as the terminals are
successfully inserted. An extraction tool is pro-
vided for removal of pin terminals if necessary.
23. Secure the connector to the bracket with the
provided #6-32 x 1/4" tapping screws and lock
washers.
24. Locate an accessory wire that is controlled by the
ignition switch (power is turned off when the ignition
switch is in the OFF position). Review the Vehicle
Harness and Motor Relay Installation section found
in the Mount Instructions for any specific
recommendations that may apply to your vehicles.
25. Route the 10-amp fuse holder red wire to this
location and trim excess length (leave the 10-amp
fuse holder in the system).
26. Open the blue, self-stripping connector and place
the end of the red wire against the inner groove stop
(end of wire must not extend from the connector
when it is closed) and the accessory wire in the
outer groove. Close the connector over the wires
using a pliers and snap the locking tab into place.
27. Connect the female spade terminal on the small red
wire from the vehicle cable to the male spade
terminal on the red wire from the vehicle harness.
28. Insert a rubber grommet into the firewall hole.
Secure harness as required with supplied cable
ties.