6
Lit. No. 62639
October 5, 2001
INSTALLATION INSTRUCTIONS
CAUTION
DO NOT OVERTIGHTEN. The lift channel must
pivot freely.
CAUTION
Do not use thread sealant/tape when connecting
hoses to swivel fittings. This could damage
product or property.
S-Hook
Blade
Guide
Flag
Clamp
5/16" X 1"
Cap Screws
Blade
Guide
Rod
Figure 11
45˚ Swivel
Fittings
Note Orientation
Straight
Swivel
Fitting
Figure 12
BLADE GUIDE ASSEMBLY
1.
Insert the pointed end of the clamp into the coil of
the blade guide rod.
2.
Attach a blade guide rod to each outer rib using
5/16" x 1" cap screws and locknuts.
(See Figure 11.)
LIFT CHANNEL, HYDRAULIC UNIT,
HYDRAULIC FITTINGS & HOSES
ASSEMBLY
1.
Place the hole end of the lift channel between the
lugs of the upper U-bracket on the lift frame. Insert a
3/4" x 3-3/4" bolt and secure with a 1/2" long spacer
and nylon jam locknut.
(Refer to Figure 15.)
4.
Install one straight swivel fitting into the lift port.
(See Figure 12.)
(Continued on next page.)
Hoses and fittings are in the hydraulics box.
2.
Remove the five 1/4" pipe plugs from the bottom
face of the valve on the hydraulic unit.
3.
Install four 45° swivel fittings into angle ram ports.
Position fittings as shown in Figure 12.
