4
Lit. No. 62639
October 5, 2001
INSTALLATION INSTRUCTIONS
Center
Deflector
Top of Pivot Pin
A-frame
Figure 6
Edges
are aligned
Figure 7
5/8" X 2-1/4"
Clevis Pin
(Insert
Towards
Center)
Lift Frame
Side Angle
1/2" X 5.5"
Stand Pin
& 3/16"
Linchpin
5/8" X 2"
Stand Lock Pin
& 3/16" Linchpin
Stand
A-frame
Stand
Lugs
A-frame
Lugs
Figure 5
LIFT FRAME
1.
Lay the lift frame on the floor with the curve facing
upwards and the ends of the side angles
positioned next to the rear (wide end) of the
A-frame.
(Refer to Figure 5 for steps 2-4.)
2.
Raise the end of the lift frame and align the holes in
the side angles between the inner pairs of lugs on
the wide end of the A-frame.
3.
Secure the lift frame to the A-frame lugs with two
5/8" x 2-1/4" clevis pins inserted from the outside
towards the center of the A-frame. Secure with
cotter pins.
4.
Rotate the lift frame to align the holes in the stand
lugs to the bottom hole of the three hole pattern in
the top of the stand. Secure with a 1/2" x 5.5" stand
pin and a 3/16" linchpin.
CENTER DEFLECTOR
1.
Lower the center deflector onto the A-frame until it
touches the top of the pivot pin.
(See Figure 6.)
2.
Push the center deflector towards the back of the
A-frame until the inside of the formed section
touches the top hinge of the A-frame.
3.
With the wings straight and the A-frame
perpendicular to the blade, align the front edge of
the center deflector with the top curl of the blade.
(See Figure 7.)
