3
Lit. No. 62639
October 5, 2001
INSTALLATION INSTRUCTIONS
5/8" X 2"
Stand
Lock Pin
& 3/16" Linchpin
3/8" X 2"
Bolt
9/16" OD Spacer
A-Frame
Center
Bars
Stand
Figure 4
Passenger Side
Mounting Plate
Weldment
Figure 3
MVP
®
Cutting Edge
MVP
®
Base Angle
Rubber Flap
Driver Side
Mounting Plate
Weldment
1/2" x 1-3/4"
Carriage Bolts
1/2" Locknut
1/2"
Washer
1/2" x 2-1/2"
Cap Screw
1/2" Washer
RUBBER FLAP
NOTE: The rubber flap can not be installed unless
the plow is attached to vehicle and in the raised
position OR raised in a different manner to provide
access to both front and rear of the cutting edge.
1.
Using four 1/2" x 1-3/4" carriage bolts and 1/2"
locknuts, install one mounting plate weldment to
the back of each cutting edge.
(See Figure 3.)
2.
Adjust wings so that they are in line with each other
or slightly forward in the scoop position.
3.
Place 1/2" washer on 1/2" x 2-1/2" cap screw and
insert cap screw into a hole in the rubber flap. The
rubber flap is mounted with the longest edge facing
the ground.
Place rubber flap against rear inside surface of the
mounting plate weldments and align holes in flap
and weldments.
Insert the cap screw through the hole in the back
plate of the mounting bracket. Add 1/2" washer and
1/2" locknut. Tighten locknut until washer slightly
deforms the rubber flap surface.
4.
Insert the second 1/2" cap screw through the rubber
flap and mounting plate weldment using the same
washer and locknut assembly as mentioned above.
STAND
(Refer to Figure 4 for steps 1-6.)
1.
Position the stand next to the center bars of the
A-frame with the long slot towards the rear or back
of the A-frame.
2.
Insert the 9/16" outside diameter spacer into the top
end of the long slot in the stand.
3.
Holding the spacer in place with a finger, insert the
stand between the A-frame center bars and align
the spacer with the small hole in the center bars.
4.
Secure the spacer with a 3/8" x 2" bolt and locknut.
5.
Hold the stand perpendicular to the A-frame. Align
the short slot in the stand with the large hole in the
center bars, and insert the 5/8" x 2" stand lock pin.
Secure with a 3/16" linchpin.
6.
Tip the snowplow assembly into the plowing
position.
