030-300408 Rev. B
97
August 2005
VersaLink™ Gateway (Model 327W)
User Guide
Enable ATM 0/21 Loopback:
Factory Default = ENABLED
This option enables the 0/21 loopback , which is used by your ISP.
NOTE: Westell does not recommend that you change this setting.
13.6.2 WAN Configuration
The following settings will be displayed if you select
WAN
from the
Advanced WAN
menu. If you change the
Bridge Broadcast,
Bridge Multicast,
or
Spanning Tree Protocol
configurations in this screen, click on the
save
filter settings
button to allow these changes to take effect. If you change any of the
Status
configurations, a pop-up
screen will prompt you to reset the Gateway. After the Gateway has been reset, the
Status
configurations will take
effect. The
edit
button allows you to change the VC configuration settings of the Gateway. Details on the
edit
button are explained later in section 13.6.3.
NOTE: The actual information displayed in this screen may vary, depending on the network connection established.
