030-300408 Rev. B
93
August 2005
VersaLink™ Gateway (Model 327W)
User Guide
If the settings you have entered in the
Public LAN Configuration
screen are incorrect, the following warnings
messages may be displayed via pop-up screens. If this occurs, check settings in the
Public LAN Configuration
screen.
Warning Message
Check Public LAN DHCP Settings
Start Address is not part of the Subnet
Check the value in the DHCP Start Address field
End Address is not part of the Subnet
Check the value in the DHCP End Address field
End Address is below the Start Address
Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds
Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 59
Check the
Seconds
field at DHCP Lease Time
Minutes must be between 0 and 59
Check the
Minutes
field at DHCP Lease Time
Hours must be between 0 and 23
Check the
Hours
field at DHCP Lease Time
If you clicked on
OK
in the
Load new Public LAN configuration?
screen, the following pop-up screen will be
displayed. This will allow the modem to be reset and the new configuration will take effect. Click on
OK.
If you clicked on
OK
in the preceding screen
,
the following screen will be displayed. VersaLink will be reset and
the new configuration will take effect.
After a brief delay, the home page will be displayed. Confirm that you have a DSL sync and that your PPP session
displays
UP.
(Click on the
connect
button to establish a PPP session).
