030-300408 Rev. B
124
August 2005
VersaLink™ Gateway (Model 327W)
User Guide
Interface
Indicates were to send the packet if it matches this route.
Metric
The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP
Indicates whether a static route should be advertised via RIP.
Host Routing Table
Host Routing Table
The list of host routes. A host route is an IP route with a 32-bit mask, indicating a
single destination (as opposed to a subnet, which could match several destinations.)
Destination Address
The IP address or subnet of the Route.
Subnet Mask
If the Route is a network route, Subnet Mask is used to specify the subnet address.
If the Route is a Host route, then the Host Route check box is used.
VersaLink
Indicates were to send the packet if it matches this route.
Interface
Indicates were to send the packet if it matches this route.
Metric
The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP
Indicates whether a static route should be advertised via RIP.
Inactive Routes
Inactive Routes
Static routes whose interface is currently not in service.
Destination Address
The IP address or subnet of the Route.
Subnet Mask
If the Route is a network route, Subnet Mask is used to specify the subnet address.
If the Route is a Host route, then the Host Route check box is used.
VersaLink
Indicates were to send the packet if it matches this route.
Interface
Indicates were to send the packet if it matches this route.
Metric
The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP
Indicates whether a static route should be advertised via RIP.
Add Route
Add Route
This is used to add a new static route in the modem.
Destination Address
The IP address or subnet of the Route.
Subnet Mask/ Host Route
If the Route is a network route, Subnet Mask is used to specify the subnet address.
If the Route is a Host route, then the Host Route check box is used.
VersaLink/IP Address
The interface to use for sending the packet, if it matches this route. (Only active
VersaLinks can be used to create a static route.)
Metric
The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP Conf
Determines whether or not to advertise the static route, using RIP. (RIP must also be
enabled before the route will be advertised.)
Save to Modem
If checked, then the route will be made permanent by saving it to flash memory. If
not checked, the route will disappear the next time the modem restarts.
