Goobay®
by Wentronic GmbH | Pillmanstraße 12
38112 Braunschweig | Germany
REV2021-02-03
V1.1aw
52718
Tower fan
1 Safety instructions
The user manual is part of the product and contains important information for correct use.
•
Read the user manual completely and carefully before use.
The user manual must be available for uncertainties and passing the
product.
• Keep this user manual.
Risk of electric shock
•
In case of emergency, during thunderstorms and after use, pull the product on its
plug housing!
If the fan comes into contact with water, this can lead to electric shock.
• Do not use the product with wet hands.
Rain splashing on the fan can cause an electric shock.
• Do not place the product near an open window.
Risk of entry
Rotating parts can pull in loose clothing, hair, curtains and the like.
•
Keep long hair and loose clothing away from the fan.
• Make sure that the fan is not near curtains or objects that can be drawn into the
fan.
This may cause injury or damage to the unit.
Risk of injury from moving parts
There are moving parts behind the protective grille of the fan.
•
Only operate the unit with the protective grille closed and intact.
• Do not use the unit if the protective grille is damaged.
•
Do not insert fingers or objects through the protective grille.
This may result in injury or damage to the product.
• Do not open the housing.
•
Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
A defective device may not be put into operation, but must be disconnected from mains
and protected against further use.
•
Use product, product parts and accessories only in perfect condition.
• In case of questions, defects, mechanical damage, trouble and other problems,
non-recoverable by the documentation, contact your dealer or producer.
•
Do not repair defective products yourself, but contact the dealer or the manufac
-
turer.
• Avoid stresses such as heat and cold, moisture and direct sunlight, microwaves,
vibrations and mechanical pressure.
•
Do not operate the product in the presence of explosive and/or flammable gases.
•
Do not place or operate the product near naked flames or heat generating pro
-
ducts such as radiators and ovens.
Not suitable for children and persons with physically and/or psychologically limited abili-
ties.
• Secure packaging, small parts and insulation against accidental use.
•
Assembly, operation, care, storage, transport, disposal may only be carried out by
end users and users with basic knowledge of mechanical and electrical enginee-
ring.
•
Do not operate the product in dusty environments and in poorly ventilated areas.
• Do not cover the product.
• Keep fan slots and ventilation slots free.
• NEVER leave the product unattended during operation.
• Disconnect the product from the mains when not in use, when accessories are at-
tached, for cleaning, or in case of malfunction.
Battery hazards
The cells are replaceable.
•
Never use batteries when they are dented, leaked or damaged.
• Remove leaked, deformed or corroded batteries from the product and dispose
them by appropriate protectives.
•
Only use batteries of the same or equivalent type as recommended.
If a battery has leaked, avoid contact with skin, eyes and mucous membranes. If neces-
sary, rinse affected areas with water and seak medical attention immediately.
• Do not deform, burn or disassemble batteries and never puncture them with a
sharp object.
Extreme heat can lead to explosion and/or leakage of corrosive liquid.
Mechanical damage can cause gaseous substances to escape, which can be highly irri-
tating, flammable or toxic.
• Do not short-circuit batteries or immerse them in liquids.
There is a risk of explosion, fire, heat, smoke and/or gas development.
•
If the battery is accidentally dropped into water, remove it immediately. Place the
battery in a safe, open area and stay away until it is completely dry. Do not reuse
the dried battery, but dispose of it as indicated in chapter 10.2.
2 Description and function
2.1 Product
The product is an oscillating, quiet tower fan with power cable.
○
3 power levels: LOW, MED, HIGH
○ integrated timer function up to 7.5 hours
○ 3 modes: Standard, NATURAL and SLEEP
2.2 Scope of delivery
Fan body, right base, left base, 3 Phillips screws (L 14 mm x Ø 4 mm), remote control,
1x lithium button cell (CR2025), User Manual
2.3 Specifications
Article number
52718
Input
220-240 V , 50 Hz
Rated power [W]
50
Fan power input (P) [W]
46.7
Standby power consumption (P
SB
) [W]
0.41
Max. fan flow rate (F) [m³/min]
4.3
Service value (SV) [(m³/min)/W]
0.09
Measurement standard for service
value
EN 50564:2011, EN ISO 5801:2017,
EN 60704-1:2010+A11:2012,
EN 60704-2-7:1998
Max. air velocity (c) [m/s]
3.0
Fan sound power level (L
WA
) [dB
A
]
59.0
Protection level / Protection class
IPX0 / II
Colour
black
Device connection
Euro plug (type C, CEE 7/16)
Cable length (incl. plug) [m]
1.6
Dimensions
W x H x D [cm]
Ø [cm]
11.7 x 76.5 x 14
22.1
Weight [g]
2550
Remote control
Type
Infrared
Input voltage
3.0 V
Dimensions [mm]
86.3 x 40 x 7
Weight [g]
10
Battery
Type
Lithium button cell (CR2025)
Nominal voltage, Capacity
3.0 V
, 150-165 mAh
Weight [g]
2.5
2.4 Operating elements and product parts
1
Function keys
2
Status indicators
3
Fan body
4
Mains cable
5
Remote control
6
Left base
7
Right base
8
Battery compartment
3 Intended use
We do not permit using the device in other ways like described in chapter
"Description and Function" or in the "Safety Instructions". Use the product only
in dry interior rooms. Not attending to these regulations and safety instructions
might cause fatal accidents, injuries, and damages to persons and property.
IPX0:
This product is not protected against water.
4 Preparation
1.
Check the scope of delivery for completeness and integrity.
2.
Compare the technical data of the product and the power supply. These must be
identical.
5 Assembly
1.
Connect the left base (6) to the right base (7) and make sure that the connection
is tight.
2.
Place the fan body (3) on the assembled base.
3.
Feed the mains cable (4) through the centre of the assembled base.
4. Fix the fan body to the base using the 3 screws.
- 3 -
Subject to change without notice.
User Manual
EN
