©
2019 WEINZIERL ENGINEERING GmbH
Page 10/41
To change the saturation via relative dimming commands, there
is the following object, if it has been activated via parameters:
Group Object
Type KNX
Size
Direction
GO 25 RGB A: Saturation adjusting rel. -
Increase/ Decrease
3.007
4 Bit
From KNX
Minimal saturation while changing with object
This parameter can be used to set the minimum saturation that
can be achieved by relative dimming. If the current saturation is
below the minimum value, the saturation cannot be reduced via
object 25.
Maximal saturation while changing with object
This parameter can be used to set the maximum saturation that
can be achieved by relative dimming. If the current saturation is
above the maximum value, the saturation cannot be increased
via object 25.
Fade time while increasing saturation
This fade time is active when the saturation is increased by rela-
tive dimming with object 25. The time period refers to a complete
dimming process of 0-100%.
Fade time while decreasing saturation
This fade time is active when the saturation is reduced by rela-
tive dimming with object 25. The period refers to a complete dim-
ming process of 0-100%.
Object set value Saturation (abs.)
The following object is used to control saturation via dimming
value, if it has been activated via parameters:
Group Object
Type KNX
Size
Direction
GO 26 RGB A: Saturation adjusting abs.
- Set value
5.001
1 Byte
From KNX
Minimal value for changing saturation with object
This parameter can be used to configure which minimum satura-
tion can be reached via object 26. If a value below the minimum
value is received, the dimmer is controlled with the minimum
value.
Minimal value for changing saturation with object
This parameter can be used to configure which maximum satura-
tion can be reached via object 26. If a value below the maximum
value is received, the dimmer is controlled with the maximum
value.
Fade time while increasing saturation
This fade time is active when the saturation is increased by val-
ues received via object 26. The period is related to a complete
dimming process of 0-100%.
Fade time while decreasing saturation
This fade time is active when the saturation is decreased by val-
ues received via object 26. The period is related to a complete
dimming process of 0-100%.
E.
RGB A: Brightness
Brightness is an attribute of a color in HSV space.
A brightness of 100% means that the color shines with maximal
possible intensity, the lower the brightness, the less bright the
color shines.
Object Brightness on/off
The following object is available for switching the brightness, if it
has been activated via parameters:
Group Object
Type KNX
Size
Direction
GO 27 RGB A: Brightness on/off - Switch
1.001
1 Bit
From KNX
Behavior on ON telegram (when Brightness 0%)
If the current brightness is 0%, this parameter can be used to
configure the behavior when switching on via object 27.
It is available:
-
No reaction
-
Dim to fix value
-
Dim to last value before switching off
Behavior on ON telegram (when Brightness >0%)
If the current brightness is greater than 0%, this parameter can
be used to configure the behavior for a new ON telegram via ob-
ject 27.
It is available:
-
No reaction
-
Dim to fix value
-
Dim to fix value if higher than actual