4427 Dawson Street
Burnaby, B.C., Canada V5C 4B8
Office: 604.502-9007
Fax: 604.502-9044
Web:
www.webbelectronicsinc.com
Document Name: MWP-302 User Manual
1 3 o f 1 7
CONFIDENTIAL, Copyright © 2018
This document is proprietary to Webb Electronics Inc. It may not be copied or otherwise
distributed without the express consent of Webb Electronics Inc.
Value Range: 10 digits (any of 1, 2 ,3, 4, 5, 6, 7, 8, 9, 0)
Factory Setting: Same as number on WebbPhone label
Description: A unique serial number is assigned to each WebbPhone and is located
on a small white label attached to the unit. This setting is programmed into the unit at
the factory and does not need to be changed.
4.5.15 OPERATING STATUS
Command #:
17
Voice Prompt:
“BATTERY”
Value Range:
0
–
6 (cannot be set)
Description:
Indicates battery, phone line and AC power status. You
may check by
pressing START, 17, REPLAY. Press EXIT when done. Or you may check by calling in
from a Rescue Station or an off-site telephone.
0 = No battery / faulty battery.
1 = Completely discharged.
2 = Low.
3 = Good.
4 = Full charge.
5 = No telephone line detected.
6 = No AC power detected.
Note: The battery strength value will play first. The unit will then play the codes for phone line and
AC power only if a problem is detected. The status of the battery will refresh every 5 minutes.
Note: The battery is a rechargeable Li-Ion battery and should have a full charge within 1 day of
the WebbPhone being connected to AC power. Even if the battery indicates a full charge, it should
be replaced every 2 years.
4.5.16 LANGUAGE
Command #: 18
Voice Prompt: “LANGUAGE”
Value Range: 0 = English, 1 = French, 2 = English / French, 3 = French / English, 4 =
English / Spanish
Factory Setting: 0
Description: The WebbPhone has built-in voice prompts to make it easier to program
the device and to assist both the passengers and monitoring station when an
emergency call is in progress. If the WebbPhone is set to either English (0) or French
(1), voice prompts heard by the passenger, programmer and monitoring station will
be played in the language chosen. With the settings English / French (2) or French /
English (3), voice prompts for both passenger and monitoring station will be heard in
the language sequence chosen. The programmer will be given the option to choose
which language they wish to hear the programming prompts in. With the English /
Spanish setting (4), all operating status information heard by passengers will be
played in English followed by Spanish. Programmers and monitoring personnel will
hear messages in English.
4.5.17 FIRMWARE VERSION NUMBER
Command #: 19
Voice Prompt: <Firmware Version Number>
Value Range: N/A
Factory Setting: <Firmware Version Number>
Description: This option can only be replayed, not programmed. When “1, 9, REPLAY”
is entered, the WebbPhone audibly announces the firmware version number.
