4427 Dawson Street
Burnaby, B.C., Canada V5C 4B8
Office: 604.502-9007
Fax: 604.502-9044
Web:
www.webbelectronicsinc.com
Document Name: MWP-302 User Manual
8 o f 1 7
CONFIDENTIAL, Copyright © 2018
This document is proprietary to Webb Electronics Inc. It may not be copied or otherwise
distributed without the express consent of Webb Electronics Inc.
To change any programming parameters, type in the command number followed by the ENTER
key. Command numbers are summarized on page 10 and detailed below.
When you are finished entering program information, the unit will return to the main
programming mode. From here you can go into another programming routine or exit from
programming mode altogether.
Press the EXIT key to escape “Programming Mode”. The WebbPhone will audibly announce
“EXIT PROGRAMMING”.
If left in “Programming Mode”, the WebbPhone will revert to normal operation after 10
minutes of inactivity.
“Programming Mode” can be re-entered by pressing the START key again.
4.3.1 PROGRAMMING EXAMPLE – PRIMARY PHONE NUMBER
The primary phone number is the first telephone number that WebbPhone will call when
the CALL button is pressed.
Press START to enter Programming Mode.
Press ‘1’ followed by ENTER. The WebbPhone will audibly announce “PRIMARY
PHONE NUMBER” to indicate that it is in the primary phone number programming
routine.
Enter all of the dialing digits followed by the ENTER key. The WebbPhone will audibly
announce “INPUT ACCEPTED. YOU ENTERED…” followed by all of the digits entered.
The WebbPhone is back in main programming mode.
To correct the information just entered, press ‘1’ again followed by ENTER and re-input
the primary phone number digits.
If an input error is detected, the WebbPhone will audibly announce “INCORRECT
ENTRY, PLEASE RE-ENTER”. Re-enter the information.
While entering the digits, before pressing ENTER, if a mistake is made, the programming
routine can be aborted by pressing EXIT. The WebbPhone audibly announces
“CANCELLED” and the unit will go back to “Programming Mode”. Press EXIT again to
leave Programming Mode.
4.4
REPLAY
While in “Programming Mode”, the current value of any programmed value can be replayed.
Simply enter the program routine number followed by the REPLAY key. The WebbPhone will
audibly announce the program routine followed by the programmed value and revert to
“Programming Mode”.
4.5
PROGRAMMING ROUTINES
The WebbPhone has 18 programming routines. They are described in more detail in the
following section. We recommend that installers familiarize themselves with these operations
to speed up programming time and to make the most of the WebbPhone features. Each
WebbPhone also has a Quick Programming instruction label for quick setup in the field.
4.5.1 PRIMARY PHONE NUMBER (Analog)
Command #: 1
Voice Prompt: “PRIMARY PHONE NUMBER”
Value Range: 25 number capacity (any digit or “#” to add a 2 sec pause).
Factory Setting: Blank
