4427 Dawson Street
Burnaby, B.C., Canada V5C 4B8
Office: 604.502-9007
Fax: 604.502-9044
Web:
www.webbelectronicsinc.com
Document Name: MWP-302 User Manual
1 4 o f 1 7
CONFIDENTIAL, Copyright © 2018
This document is proprietary to Webb Electronics Inc. It may not be copied or otherwise
distributed without the express consent of Webb Electronics Inc.
4.5.18 * / # Speaker / Mic Volume
Command #: * and #
Voice Prompt: Single beep is played immediately after entering a number
Value Range: 1 – 6
Factory Setting: 3
Description: This function sets the volume (*) and mic (#) levels, with 1 being the
lowest level, and 6 being the highest. Note that the ‘enter’ key is not needed after
changing the value. For example, pressing *, 4 (while in program mode) will set the
volume level to 4, followed by a single beep at volume level 4.
Note: A good way to test the microphone levels is to record a location announcement.
Note: In two-way communications, if one end of the transmission is too quiet, it may not always
be the best solution to immediately increase the volume or mic levels to the maximum. Instead,
increase each setting incrementally. The reason for this is the software echo cancelation.
4.6
REMOTE PROGRAMMING
The same functions are available in remote programming as when programming directly
on the WebbPhone keypad. Minor variations are noted below:
Keypad
Equivalent Remote Sequence
START
99* + Valid Access Code
EXIT
*9
ENTER
**
REPLAY
#
Table 4 – Remote Programming
To program remotely:
1- From any phone, call the telephone number of the line connected to the
WebbPhone. Once you hear the voice prompt, enter the selected station number
followed by the * key.
2- Enter 99*. This will instruct the WebbPhone to commence entering into “Programming
Mode” The WebbPhone will audibly prompt with “ACCESS CODE”.
3- Enter the 5-digit access code. (Factory default is 12345). If the entry is correct, you will
hear the prompt “PROGRAM MODE” followed by the normal two confirmation beeps. If
the access code is incorrect, you will hear the prompt “INCORRECT ENTRY. PLEASE
RE-ENTER.” and the unit will wait for new data to be entered.
To remotely program another cab, hang up and call back into the system. Starting at step 1,
go through the same steps again using the new cab number.
5 CALLING INTO WEBBPHONE UNITS
If Auto Answer is set to “1”, all WebbPhones on the line will answer incoming calls after the first ring. A voice prompt
will then play directing the caller to enter the desired station number followed by the * key.
Pressing 1* will connect to the first WebbPhone, 2* to the second WebbPhone, etc. Two-way communications is not
established until a specific station is selected.
If Auto Answer is set to “1”, the passenger will see the LED turn on. After the desired station has been
selected and two-way communications is established, both parties will hear the word “CONNECTED”
and the LED will begin to flash. If Auto Answer is set to “2”, the LED will not turn on, and the passenger
won’t hear the word “CONNECTED”.