4427 Dawson Street
Burnaby, B.C., Canada V5C 4B8
Office: 604.502-9007
Fax: 604.502-9044
Web:
www.webbelectronicsinc.com
Document Name: MWP-302 User Manual
1 1 o f 1 7
CONFIDENTIAL, Copyright © 2018
This document is proprietary to Webb Electronics Inc. It may not be copied or otherwise
distributed without the express consent of Webb Electronics Inc.
Description: This is the number of rings that the WebbPhone will count after dialing
the primary phone number before concluding that there has been no answer. After
the last ring, the unit will hang up and perform the appropriate action. This would either
be to call the next dialing destination or to hang up if 3 calling cycles have been
completed.
4.5.9 SECONDARY RING TRANSFER COUNT
Command #:
9
Voice Prompt:
“SECONDARY RING TRANSFER COUNT”
Value Range:
1
–
20 rings
Factory Setting:
5
Description: This function serves the same purpose as Function 8, except that it
applies to the number of rings counted after dialing the secondary phone number.
4.5.10 OPERATOR WAIT TIME
Command #:
10
Voice Prompt:
“OPERATOR WAIT TIME”
Value Range:
20
–
200 seconds
Factory Setting:
90 seconds
Description: This is the length of time that the WebbPhone will permit a caller to be
put on hold before it hangs up and dials the next number in its sequence. The timer
is cancelled as soon as the operator presses the 1 key to speak to the caller or the 2
key to listen to the location announcement.
Note: This value is unused if Operator Prompt is OFF (see following).
4.5.11 OPERATOR PROMPT
Command #:
11
Voice Prompt:
“OPERATOR PROMPT”
Value Range:
0 = OFF, 1 = ON
Factory Setting:
1
Description: When ON, a prompt message will repeat itself until either the operator
presses the appropriate key, or the Operator Wait Time period expires. The
passenger will hear a “CALL IN PROGRESS” message until the operator comes
online. When OFF, the WebbPhone will be in two-way communication mode as soon
as a voice is heard or ringing stops. The chart below shows how the various settings
affect the flashing LED and the message played.
Activate
Location
When Alert
Operator
Message Played
LED Begins
Announcement
Prompt
Flashing
0 (OFF)
Blank or Recorded
No message played
As soon as call
answered
1 (ON)
Blank
“Incoming Webb emergency
After operator
call. Push 1 to speak to caller.”
presses ‘1’
“Incoming Webb emergency
After operator
1 (ON)
Recorded
call. Push 1 to speak to caller,
presses ‘1’
or 2 to hear the location.”
Table 3 – Operator Prompt
