12
Unpacking, Assembling, and Powering the MViQ
Unpacking and Putting Away the
System (Small Case)
Caution: If you do not pack the system carefully,
as described, damage might occur.
1
– The insertion tube (shown in red for clarity) is held
in the case’s internal storage reel, which is accessed
through the orange funnel shown here. Install the
insertion tube before installing the probe-and-
handset assembly and remove it after removing the
probe-and-handset assembly. Be sure to straighten
any loops or twists in the insertion tube before feeding
it into the funnel. Note that the insertion tube’s rubber
Torsional Strain Relief base should be routed through
the case’s curved passage shown here.
Caution: Before storing the insertion tube, first
remove the optical tip and install the head guard to
protect the tip attachment mechanism. Keep the
head guard on whenever no optical tip is in place.
2
– Install clamp in the orientation shown here (clamp and mounting bracket assembly appears
at left)
3
– Power supply / Battery Charger and Mounting Bracket are oriented and installed in this slot
4
– Battery must be removed prior to installing the iQ in the case.
5
– Rigidizer
6
– A case holding OTA's (or cleaning kit) fits in this slot.
7
– Gripper may be used alone, or with Rigidizer, to aid in orienting camera.
