Waters 2489, Operator'S Manual

Page: 38 / 234

2-6 Installing the Detector
Unpacking
To unpack the detector
1. Unpack the contents of the shipping carton. As you unpack the carton,
check the contents to make sure you have received all items.
2. Check the contents of the startup kit.
3. Save the shipping carton for future transport or shipment.
Inspecting
If you see any damage or discrepancy when you inspect the contents of the
carton, immediately contact the shipping agent and Waters Technical Service
at 1-800-252-4752, U.S. and Canadian customers only. Other customers, call
your local Waters subsidiary or your local Waters Technical Service
Representative, or call Waters corporate headquarters for assistance at
1-508-478-2000 (U.S.).
Tip: Make sure the instrument serial number, found on the nameplate on the
rear panel or inside the front left panel of the detector, corresponds to the
number on the instrument integrity certificate.
For more information about the instrument warranty, see Waters Licenses,
Warranties, and Support Services.
Making fluid line connections
Before initial startup of the detector
1. Complete the fluid line connections described in this section.
2. Complete the electrical connections described in “Making electrical
power connections” on page 2-9 .
Caution: Observe Good Laboratory Practices when handling
solvents. Refer to the Material Safety Data Sheets for the
solvents in use.