Chapter 5 Placement of Decals
38
INSTALLATION OF DRIVE-OVER WARNING DECAL
The following decal is to be positioned in a conspicuous
place near the control switches as shown.
80100592 – Drive Over Decal
If unit is equipped with drive over kit decal
80101330 must be used in place of decal
80100592
.
INSTALLATION OF CONTROL DECALS
Install all decals listed below. Be certain they are
installed in the proper location and are legible.
All decals must be in place and legible or all
warranties are void.
Each of the following four (4) decals are to be positioned
in a conspicuous place near the control switches as
shown.
80100850 – Safety Instruction Decal
80101451 – Operation Decal
80100828 – Important Decal
80101370 – Hazard decal
One (1) of the following three (2) decals is to be
positioned in a conspicuous place near the control
switches as shown.
If your liftgate is equipped with dual
controls, an additional Safety Instruction
decal (80100850) is to be placed in a
conspicuous place near the second set of
controls.
PLACE DECALS IN THIS AREA
GR02913
To maximize decal adhesion to surfaces:
•
Surface must be dry and clean
•
Firm pressure must be applied to decal
•
Minimum surface temperature 65º
Heat gun may be used to heat surface
GR02913A
80101415 –
HDC
-33 Capacity Decal
80101416 –
HDC
-44 Capacity Decal