Chapter 4 Liftgate Installation
INSTALLATION OF POWER CABLE
AND OPTIONAL IN CAB SWITCH
In the next section we will take you through installation of the Control Switch, In Cab Switch if supplied and powering
the liftgate to the batteries.
As part of the liftgate you will find a Grey insulated cable
that has an orange and black wire. This is used for wiring
the In Cab Switch.
Run the grey insulated wire for the In
Cab Switch down the
chassis frame.
Install the In Cab switch
and open platform light
to the
dash.
The black wire runs to the center post of the switch
Run a ground from the
Bronze post of the switch to any
ground point near the dash
Connect a wire to the
silver
post
and connect other end
t
o
+12VDC fused power aux source in the cab
If you are not running an in cab switch you will need to
follow the instruction for accessing the relay
card to
install
a jumper between CS
and CS+
as shown in the diagram.
If not installing In Cab
Switch install a
Jumper between CS
and CS+
Protect wires from any sharp edges or holes
that may abrade insulated covering of wires.
Secure
wire
so it does not come near, or in
contact with, other vehicle wiring, fuel lines,
brake lines, air hoses, exhaust system, etc.
20
