Chapter 4 Liftgate Installation
14
GR00063
Jack mount frame up to the proper “A” Dimension.
Refer to the Mounting Requirements in this manual.
Note
: Use the smallest “A” Dimension per the chart, this
insures the greatest ground clearance.
Important
: Top of mount tube is not to contact the
vehicle chassis frame.
Position mount plates over mount tube, and up against
vehicle chassis frame.
Open end of mount plates must face front of vehicle.
TRIM MOUNT PLATE
Rotate liftgate and mount plate so plate is 90
°
degrees
to chassis frame.
Drill ½” holes, centered in slots, through chassis frame.
Note
: In some installations it may be necessary to trim
off top of mount plates to clear body cross members.
After modification a minimum of 6 of the outer holes must
remain available for use.
GR00064
