8 IP Modem Function
8.5.19 AT &K (handshake) [AT&K3]
or as alternative command . . .
8.5.20 AT \Q [AT\Q3]
Configure serial Flow Control. AT&K0 and AT\Q0 disable all Flow Control. The default is AT&K3
and AT\Q3 to use RTS/CTS Hardware Flow Control between PC and IP Modem. AT&K4 and
AT\Q1 configure for XON/XOFF Software Flow Control between PC and IP Modem. Other
Options are not supported.
8.5.21 AT &V (view profile)
Show Profiles. This will display the current profile, the stored user profile, the short dial strings
and the factory profile. Parameters are accepted but ignored. AT&V is AT&V0 and is AT&V1.
8.5.22 AT &W (save profile)
Save the current configuration as user profile. AT&W is the same as AT&W0, all other parameters
report an ERROR.
8.5.23 AT &Z (save destination)
This command will save a destination in Internet syntax. It is given by <host>:<port>. The
<host> is either an IP Address in dotted octet notation, or an FQN in correct syntax. The <port>
is a string representing a decimal number. If :<port> is omitted, the target port is the local TCP
Data Port as defined in the configuration of IP Modem (see
6.2.2.2.7
above).
September 2016
NetCom Plus User Manual
104
Summary of Contents for NetCom Plus 111
Page 133: ......
