6 Configure the Operation Modes
may discard all changes done. For many configuration changes the NetCom
+
requires a reboot to
proceed, especially if the IP parameters have been updated.
The Telnet section has a separate menu for saving configurations, described later.
6.2.2 Serial Port Configuration
In your web browser click on the Icon of “SERIAL CONFIGURATION”. This is a huge menu in
the web browser. Each serial port of the NetCom
+
is listed in a separate Column. A maximum of
four serial ports is shown at one time. Select the appropriate group of ports.
Figure 70: Port Page Selection in Web Browser
The top half of the parameters titled “Serial Settings” is directly related to common serial configu-
rations. The bottom half titled “Transfer Settings” configures the operation mode of NetCom
+
on
the network. Each serial port is configured separately, there is no setting shared between ports.
Note: The list of serial ports will automatically expand, when supported USB–COM Plus module(s)
are detected. With two or more modules always have the connection scheme the same. Otherwise
physical ports will change numbers, and the configuration will be confused.
In the Telnet menu select “SerialPorts” in the Main Menu, and directly select the serial port to
configure.
The settings available in this menu are by port. Therefore, first the port to configure has to be
chosen.
SerialPorts
+----------+
|
Port 1
|
|
Port 2
|
|
Port 3
|
|
Port 4
|
+----------+
SerialPorts
+---------------------+
|
Serial Settings
|
|
Transfer Settings
|
+---------------------+
Figure 71: Port Selection in Telnet
Just select the port by placing the cursor, and then press <Enter>. The next option is to configure
the
Serial Settings
or the
Transfer Settings
.
September 2016
NetCom Plus User Manual
73
Summary of Contents for NetCom Plus 111
Page 133: ......
