8 IP Modem Function
ATI or
ATI0
230
230.4kbps maximum
ATI1
100000000
100Mbps Ethernet
ATI2
ATI3
Version 1.0 / <compile-date>
Version of Modem-Firmware
ATI4
Current Profile
ATI5
ATI6
NetCom 230k IP-Modem
Device Identification
ATI7
ATI8
ATI9
(<Name>\Serial#\IP-#:port\Com-X\NetCom)
Display serial port used
ATI10
ATI11
<very extended information>
Table 26: IP Modem Information Responses
8.5.10 AT S (setup)
Set and read the S-registers for configuration. ATSrr? is a request to read the current value of
S-register number rr, ATSrr=nnn stores the value nnn in the register rr. Unknown registers report
ERROR. See section
8.4.2
above for possible registers and parameters.
8.5.11 AT L (loudness)
and
8.5.12 AT M (speaker)
These commands are answered with OK, but completely ignored.
There is no function like
speaker.
8.5.13 AT N (auto baud) [ATN0]
Automatic detection of serial speed. For hardware reasons this detection is not implemented. The
command ATN0 to disable automatic detection is accepted and answered with OK. The ATN1 to
enable automatic detection is not available, and answered with the ERROR response.
8.5.14 AT Z (reset)
Reset the configuration to a stored profile. IP Modem only supports profile 0 for simplicity. Same
as ATZ0 or as AT&F or AT&F0.
September 2016
NetCom Plus User Manual
102
Summary of Contents for NetCom Plus 111
Page 133: ......
