5 Configure with NetCom Manager
Some ISP will block the SNMP protocol, which typically means they do not transport data for
161/udp to their customers (this is the first reason why port 8161 was used in the example).
This answer brings every required information about the NetCom
+
, including its
internal
IP Address.
Select the panel of NetCom Manager Server Settings to verify the information, but do not make
any changes here. Changing the configuration may disconnect the NetCom
+
from the protected
LAN.
5.6.4 Serial Ports through SOHO Firewall
Now the NetCom
+
is available in the NetCom Manager, but still the serial ports are not usable.
The information of the TCP-ports for the ViServ related to the serial port is still missing. In the
NetCom Manager Server Settings select the NetCom Manager
Ports
Panel. In this panel select one
serial port, in this example of NetCom Plus 111 there is only one serial port. Click the
Properties
button to open the configuration of the port.
Figure 54: NetCom Manager Port Configuration for Driver
Since the Firewall function is enabled, the parameters for
Firewall mapping
are available for
editing. Enter the ports defined in the Router, 9001 and 9000 in this example. Please note, so
far there is no number for the Virtual Com Port available. The driver is not installed in this
moment, and Windows does not know about the available hardware. This will happen later in the
installation. Click the
OK
button, and proceed with the driver installation as already described.
September 2016
NetCom Plus User Manual
57
Summary of Contents for NetCom Plus 111
Page 133: ......
