G
ATEWAY
C
ONTROLLER
S
ERIES
U
SER
M
ANUAL
VALUEPOINT NETWORKS, INC. ALL RIGHTS RESERVED
P
AGE
90
OF
135
Erase Tunnel
Reset tunnel name and values to default
Tunnel Name
By default, the tunnels are named
VPN1 – VPN10.
You
can change the name of the currently selected tunnel in the
Tunnel Name field.
Local VPN IP/Subnet
IP address and subnet of the network on the Controller that
you want to access the network on the remote gateway
through VPN.
Remote VPN IP/Subnet
IP address and subnet of the network on the remote
gateway that you want to access the Controller network
through VPN.
Note: If there is an overlap between the two network subnets, traffic to the overlapping
addresses will not be sent through the tunnel. This m ight be the case if you have a central
VPN term inator that serves m ultiple Controllers.
Remote Gateway IP
WAN IP of the remote gateway
VPN ID Type and VPN ID
The ID used for the tunnels is the WAN IP of the VPN
gateways. This is not configurable, so make sure the other
gateway matches.
Tunnel Encryption
Traffic through the VPN tunnel is strongly encrypted to insure privacy. The VPN
connections can run in two modes, manual or automatic. In automatic mode, the
encryption keys are generated and regenerated automatically. In manual mode, you
provide all the static keys. The mode selected under Keying Method affects all
tunnels. You cannot mix manual and automatic tunnels.
Keying Method
Select
Automatic
or
Manual keying
