VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
38
While the compressor system will function without the following accessories,
VMAC strongly recommends their use for optimal performance.
Receiver Tank
A receiver tank reduces the duty cycle of the compressor, and can help the
G300004 run tools with higher cfm requirements. It can also provide a buffer so
that tools can be used immediately upon system start up.
For information on installing an air receiver tank see the “Air Receiver Tank” section
of this manual on page 39.
Air receiver tanks are available for purchase through VMAC. See the “Accessory
Products from VMAC” section of this manual on page 42 for more information.
Pressure Gauge
While not critical to system performance, a pressure gauge is important for fine
tuning the system and simplifies any potential troubleshooting.
Install a 200 psi pressure gauge downstream of the air discharge valve.
Pressure Regulator and/or Lubricator or FRL
The compressor can produce air pressures up to approximately 140 psi (965 kPa). It
is the responsibility of the user to know the pressure and air flow requirements of
the tools powered by the air compressor system.
An appropriate air pressure regulator and lubricator can be installed downstream
of the air discharge valve. Failure to regulate the air pressure may cause damage
to the tool.
FRL’s are available for purchase through VMAC. See the “Accessory Products from
VMAC” section of this manual on page 42 for more information.
External Fuel Supply / Shut Off Valve
Recommended Accessories
The use of any type of external fuel supply (e.g. gravity tank) or
remote fuel shut off valves are not recommended or supported by
VMAC.
Contact a Honda Engine dealer for information regarding external
fuel supply or remote shut off valves.
