VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
86
Compressor Replacement
Read the “Maintenance and Repair Safety” section prior to
performing any work on the system (beginning on page 47).
Wear appropriate Personal Protective Equipment and follow all
industry standard safety practices.
☐
Remove the (×4) fasteners from the belt guard and remove the belt guard (Figure 63).
Figure 63 — Inspecting the drive belt
Remove
fasteners (×4)
☐
Using a 3/8 in drive, remove tension from the drive belt.
☐
Remove the belt and set it aside for later.
☐
Disconnect the 3/4 in hose from the rear of the compressor.
☐
Disconnect the 1/2 in hose from the side of the compressor.
☐
Disconnect the 3 PTFE tubes from the compressor.
After disconnecting the hoses and PTFE tubes, plug the ends to
prevent contaminants from entering the system.
☐
Remove the coalescing filter from the WHASP Tank and set it aside.
☐
Remove the air filter from the compressor and set it aside.
