VIPER user manual V1.0
40
3.2.7. Motion Setup ( VK2 Cameras only)
In this menu, the user can set the motion area setting on the screen. Select the Mode to On position to
click Setup button. Once the user clicks the desired setup channel, a motion setup window will appear.
Check the motion Enable box and adjust the sensitivity and Interval value. This will set the motion
detection zone within the VK2 camera.
3.2.8. Event Recording Duration
You can set the beginning and ending point of a recording on an event.
1) Pre Event: The recording of an event will start at a pre-determined time prior to the actual
occurrence of the event. If it is set to 5 seconds, the recording begins from 5 seconds before the
event.
2) Post Event: The recording will continue for a pre-determined time after the actual end of an event.
If it is set to 5 seconds, the recording ends in 5 seconds after an event ending. You can set up the
Post Event to maximum of 6 hours.
3) When the event recording duration setup is complete, click <OK>.
If the user sets the Pre-Event and Post-Event as Off, then the system will not record the Event.
