Option
Instructions
At the end of the test process, the KP-250 PG2 will present the devices' status:
"
Zxx: 24hr: <status>
"
8
"
Zxx: NOW: <status>
"
1
.
Note:
Refer to "
SHOW ALL DEVICES
" section for further information on device
status.
SHOW ALL DEVICES
You can view the devices status.
Note:
This option is available only after testing process was done.
Press
to view the devices' status.
The following screen will appear:
"
Zxx: 24hr: <status>
"
1
"
Zxx: NOW: <status>
"
1
Use
to scroll between the device's families.
SHOW RF PROBLEMS
You can view only the devices which have RF problems.
Note:
This option is available only after testing process was done.
Press
to view the devices' status.
The following screen will appear:
"
Zxx: 24hr: <status>
"
1
"
Zxx: NOW: <status>
"
1
Use
to scroll between the device's families.
<OK> to exit
Select to terminate the diagnostics test.
3.9.3 Testing the GSM module
The KP-250 PG2 enables to test the GSM module integrated inside the panel.
07:DIAGNOSTICS
⋅⋅⋅
GSM/GPRS
PLEASE WAIT..
Enter the "
GSM/GPRS
" menu, and press
to initiate the GSM diagnostic test. Upon test completion, the KP-250
PG2 will present the test result.
The following table presents the test result messages
Message
Description
Unit is OK
GSM / GPRS is functioning correctly
GSM com. loss
GSM/GPRS module does not communicate with the Panel
8
The signal strength indications are as follows: "
STRONG
";
GOOD
"; "
POOR
"; "
1-WAY
" (the device operates in 1-way
mode or, the "
NOW
" communication test failed); "
NOT TST
" (results are shown without any performed test); "
NOT
NET
" [device is not networked (not fully enrolled)]; "
NONE
" (keyfob 24Hr result); or "
EARLY
" (result of the last 24Hrs
without statistics).
D-306919 KP-250 PG2 Installer’s Guide
67
