VIPA IM 253 DP Series, Manual, Page: 53 / 100

Manual VIPA System 200V Chapter 3 Deployment IM 253DP
HB97E - IM - RE_253-xDPxx - Rev. 12/44 3-13
IM 253-xDPxx - DP-V0 slave - Parameters
At deployment of DP slaves presented in this manual there are 4
parameters for configuration that are individually used for every slave.
The following parameters are available:
Slot number
For reasons of compatibility to VIPA slaves with revision level 4 or lower, you
may here select the start number of the slot numeration. With
DP slaves rev. level 5 and higher, this parameter is ignored.
The following values are possible:
0: slot number 0 (default)
1: slot number 1
Sync Mode
The SYNC-Mode synchronizes the V-Bus cycle (VIPA backplane bus com-
munication) and the DP cycle (PROFIBUS DP communication).
This guarantees that there is one PROFIBUS transmission per V-Bus cycle.
The following values are possible:
Sync Mode off: DP and V-Bus cycle are asynchronous (default)
Sync Mode on: DP and V-Bus cycle are synchronous
Diagnostic
Via this parameter you influence the diagnostic function of the slaves. The
following values are possible:
activated: activates the diagnostic function of the slaves (default)
deactivated: deactivates the diagnostic function of the slaves
Redundancy diagnostic
Via this parameter you may influence the redundant diagnostic function of the
slaves and it is only accepted with redundant slaves.
The following values are possible:
activated: activates the red. diagnostic function of the slaves (default)
deactivated: deactivates the redundant diagnostic function of the slaves
Overview
Parameters