VIPA IM 253 DP Series, Manual, Page: 18 / 100

Chapter 1 Basics and Assembly Manual VIPA System 200V
1-10 HB97E - IM - RE_253-xDPxx - Rev. 12/44
•
Install the profile rail. Make sure that a clearance of at least 60mm
exists above and 80mm below the middle of the profile rail.
•
Press the bus connector into the profile rail until it clips securely into
place and the bus-connectors look out from the profile rail. This
provides the basis for the installation of your modules.
•
Start at the outer left location with the installation of your head module
and install the peripheral modules to the right of this.
[1] Head module
(double width)
[2] Head module
(single width)
[3] Peripheral module
1 2
4
3
[4] Guide rails
•
Insert the module that you are installing into the profile rail at an angle
of 45 degrees from the top and rotate the module into place until it
clicks into the profile rail with an audible click. The proper connection
to the backplane bus can only be guaranteed when the module has
properly clicked into place.
Clack
Attention!
Power must be turned off before modules are
installed or removed!
Assembly
procedure