85
Speedlifter stem
11.2.2
Handlebar direction
1.
Unscrew both clamp screws on the handlebar stem anti-
clockwise until the handlebar stem is loose enough to be
turned (see Fig.
“Operating elements of the Speedlifter”
).
2. Align the handlebars to be perpendicular to the front wheel
(see Fig.
“Handlebar direction”
).
3. Turn the screws clockwise and tighten them in accordance
with the torque.
note:
This setting should only be applied once.
Fig. Handlebar direction
1 Riding position
2 Transport position
1
2
11.2.3
Handlebar position
Fig. Handlebar position
1 Handlebar clamp
2 Clamp screw
3 Calibration
+20°
+10°
0
-10°
-20°
+20°
+10°
0
-10°
-20°
2
1
3
note:
Adjusting the handlebar position requires simultaneous
adjustment of the hand brake levers and bell position, if necessary.
1. Turn the four clamp ring screws for the handlebar position
anticlockwise until the handlebar is loose enough to be
turned in the clamp ring.
2. Rotate the handlebar so the lever of the brakes and the bell
can be easily operated while riding.
3. Tighten the screws evenly and alternately until the handlebar
no longer turns.
4. Tighten the screws diagonally.
5.
If you cannot easily operate the components on the handle-
bar while riding, adjust the position of the components.
