How To ...
18
© 1995-2005 Vibration Research Corporation. All rights reserved.
dialog box.
8.
Enter "Demo" into the "Licensed to" field of the
.
9.
Click the OK button.
If
VibrationVIEW
is not already configured for Simulation mode:
10. Select the
menu command.
11. Set the "Network Card Address" setting to "Simulation" using the drop-down list.
12. Click the OK button.
2.2.10 How to register file viewer mode.
How to register File Viewer mode
To enable
VibrationVIEW
in File Viewer mode, do the following:
1.
Select the Help..Enter Registration Code menu command.
2.
Enter your Vibration Research supplied User Name into the "Licensed to" field of the
3.
Enter your Vibration Research supplied Registration code into the "Registration code" field of the
4.
Click the OK button.
If
VibrationVIEW
is not already configured for FileViewer mode:
5.
Select the
menu command.
6.
Set "Network Card Address" to "File Viewer".
7.
Click the OK button.
Note: File Viewer mode is an optional component.
If you have purchased a license for File Viewer
mode, a letter containing your registration code will have been included with your controller
documentation.
2.2.11 How to read the front panel lights
How to Read the Front Panel Lights
Power
The Power Light will be lit whenever the power is turned on (switch on rear of VR8500). If the
power light fails to illuminate, verify that the power cord is plugged into a live outlet and the power
switch is turned on.
If the Power light ever flashes or flickers while the power switch is turned on, the
unit may require service. Contact Vibration Research for assistance.
Status
Flashing with one flash every 2 seconds (one second on. one second off) indicates that the
box has not been initialized yet. Rapid flashing indicates the box is in the process of initializing.
Flashing with a brief flash on once every 2 seconds (mostly off, with just a brief flash on) indicates the
box is initialized, but is in standby mode waiting for
VibrationVIEW
software to communicate with it.
Flashing steadily with one flash every second (half second on, half second off) indicates that the box is
connected to
VibrationVIEW,
but is waiting for additional boxes to connect before entering the active
state. Flashing with a brief flash off once every second (mostly on, with just a brief flash off) indicates
the box is connected to
VibrationVIEW
and is active.
Fault
The fault light illuminates briefly for a lamp check when the box is initially powered on, and
when the box is reinitializing.
While the Status light is blinking, the Fault light will turn on solid if there is
no network cable connecting the unit to a computer or network switch, or the network cable is the
wrong type (crossover for 8500-to-computer, straight for 8500-to-switch). When a network cable is
connected the Fault light will turn off. If the fault light is continuously on while the status light is
278
104
278
278
104
Summary of Contents for VibrationVIEW
