VibrationVIEW Help
167
© 1995-2005 Vibration Research Corporation. All rights reserved.
of the sweep. For example, if "in" (inches, in English units) is the unit selected, displacement will be
controlled, if "in/sec" is selected, velocity will be controlled and if "G" is selected, acceleration will be
controlled. Therefore, if you need a constant displacement section, set the units selection to a
displacement unit (e.g. "in").
If the frequency sweep is linear (Hz/min), ramped amplitude sweeps will be straight lines on linear
graphs. If the frequency sweep is logarithmic, ramped amplitude sweeps will be straight lines on log-
log graphs. The frequency can be swept up, swept down, or held at the start frequency.
The Sine-on-Random control mode is an optional feature; the software key must be programmed to
enable it.
4.3.9
Notch tab
Random Define Notch tab
Clicking the "Notch" tab on the
dialog box accesses this dialog box.
110
Summary of Contents for VibrationVIEW
