Vatech Premium PAX-i3D, User Manual

Page: 149 / 204

13. Cleaning and Maintenance
PCT-90LH User Manual 143
EN
G
LISH
13. Cleaning and Maintenance
The equipment has to be installed and maintained on a flat surface.
13.1 Cleaning
Always turn off the power to the equipment and disconnect it from the
power outlet before cleaning.

Thoroughly clean the areas of the equipment that comes in direct contacts with
the patient, such as the Handle Frame, the Chinrest and the Bite Block.

Do not use spray cleaners or solvents as they could flow into the equipment and
damage the electrical components or cause a fire.

Do not use abrasive liquids such as acetone, gas, or oil, which may cause
corrosion on the surface of the equipment.

Do not use any cleaning products which contain silicon. They could potentially
damage the equipment’s electrical components.
The following table summarizes the standard cleaning procedures to be performed by
the operator.
Components Cleaning Process
Bite Block
Clean with ethanol and gently wipe with a dry towel
before the next patient.
Headrest
Clean with ethanol and gently wipe with a dry towel
before the next patient.
Chinrest
Clean with ethanol and gently wipe with a dry towel
before the next patient.
Computer and peripherals Follow the manufacturers’ instructions found in the
accompanying manuals.
Outer covers of equipment Wipe the unit with a dry cloth at the end of each day.
Do not use cleaning agents in aerosol or spray form directly on the
surface of the equipment.