Van Der Stahl PTT-100 V, Operating Instructions Manual

Page: 12 / 48

PTT-100V Operating Instructions Ver.4.03E
12
The thin-film grip on the measurement side is not
attached at the time of factory shipment. Insert a pin to
fix the grip as in the following directions.
1
Set the thin-film grip on the measurement side
to the sensor axis as in the illustration on the
right.
2
Insert a fixing Pin when the hole of the chuck
and sensor axis overlap.
1
Insert the lens to the body.
1
Make sure that the machine power switch is in
OFF position.
2
Insert the female plug of the power cord into
the mains socket of the machine.
3
Next, plug the power cord into the wall outlet
that has adequate current carrying capacity as
described in “1 Specification” on page 7.
6 Operation
6-1 Set the thin-film grips
6-3 Plugging in the electrical power cord
6-2 Insert the lens
Grip fixing pin
Load-cell axis
VIU lens
Insert the lens so the longer side of
the cutout comes right when facing
toward the machine.
Thin-film grip on the
measurement side
Caution
Remove the thin-film grip on the
measurement side when not using the
machine for a while or at the time of the
shipment.
Caution
Do not apply excess force on the load cell
axis. The load cell may be damaged.
Attention
Make sure that the lens is facing
the proper direction. Otherwise, it
may not insert.
Caution
VIU lens is made of plastic lens. Do
not drop or scratch it.