Van Der Stahl PTT-100 V, Operating Instructions Manual

Page: 36 / 48

PTT-100V Operating Instructions Ver.4.03E
36
INITIALIZE ROM
INITIALIZE ROM
FINISH
MENU 8
INITIALIZE ROM
INITIALIZE ROM
PUSH < & > KEY
When the PTT-100V is connected to a PC, the test result is automatically transferred to the PC every time the
test is completed. The test result is also stored on the on-board memory of the PTT-100V which can store up
to120 test results. When the on-board memory becomes full, the display shows the following message.
By selecting OK, you allow the machine to continue the test by erasing the oldest data. If NO is selected, the
machine does not perform the next test and goes back to the date/time screen.
To avoid each data mixing up with others, you can erase the data with the following procedures. This
operation will erase all the data stored to the on-board memory, so please be careful not to lose the important
data. If you need to keep the data, connect the PTT-100V to the PC and make sure all the data has been saved
using the PTT-100V included in the accessories.
The PTT-100V can be connected to a PC with the attached USB cable, and the test results can be transferred
to the PC using the application software. For the installation of the PC application for PTT-100V and its
operating method, please contact Van der Stahl Scientific, Inc.
1 Access the menu in the right procedure.
You can delete the test data from the on-board memory with the following procedures.
2 The display now shows the right screen.
3 Press and buttons together to delete all the test
data. Wait until the display shows “FINISH”.
4 Press the button to return to the menu screen.
9 Memory on hard disk
10 Connecting to PC
9-1 <MENU8> Initialize ROM
OVER WRITE OK?
OK : ENTER / NO : STOP
Caution
You cannot perform the next test unless you permit the overwriting. If you want to keep the data,
transfer the data to your PC before proceeding the operation.
Attention
The ID’s, test patterns and the other
settings will not be deleted.