23
geoTHERM exclusive VWS 0020051614_00 installation instructions
Before separating the two modules, you must unscrew
the connections from the heat pump to the domestic
hot water cylinder.
• Unscrew the connection to the domestic hot water
cylinder supply (
1
) on the right side of the unit.
• Unscrew the connection to the domestic hot water
cylinder return (
2
) on the rear side of the cylinder.
• Unscrew the four fixing screws (
3
) on the frame of the
unit.
d
Danger!
Risk of injury!
If not filled up, the domestic hot water
cylinder module weights approx. 100 kg.
At least two people should lift it in order
to avoid injuries.
• Lift the domestic hot water cylinder module and put it
carefully on the floor.
You can now convey both modules separately to the in-
stallation site. After the transport, reassemble both to-
gether in reversed order
4.11
Flap up the electric powered switch cabinet
During the delivery, the electric powered switch cabinet
is folded downward, so that the electrical components
are protected. Before the electrical installation, you
must flap it up and clamp.
Figure 4.13 Flapping up the electric powered switch cabinet
• Remove the corrugated head screws (
1
).
• Carefully flap the electric powered switch cabinet up-
wards (
2
). Pay attention neither to clamp any line nor
damage it.
• Clamp the electric powered switch cabinet with both
corrugated head screws (
3
).
Assembly and installation 4
Summary of Contents for geoTHERM exclusive
Page 91: ......
Page 92: ...0020051614_00 GB 102008...
