Chapter 3: Configuration and commissioning
54
ZP1-X3E Series Installation Manual
Earth fault check
Use this menu to configure the earth fault check, on or off. This determines
whether the earth fault is supervised or not. The default setting is On.
Note:
If disabled, it does not comply with EN 54-2 and EN 54-4.
To configure the earth fault check:
1. Set the display as shown below, and then press Enter.
The earth fault LED flashes fast to indicate that the battery fault check menu
is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your change
The available settings for this feature are shown below.
Display
Description
The earth fault check is enabled.
The earth fault check is disabled.
Fault latch
Use this menu to configure the fault latch, on or off. This determines whether the
power supply fault is latched or not. The default setting is On.
To configure the fault latch:
1. Set the display as shown below, and then press Enter.
The general fault LED flashes fast to indicate that the fault latch menu is
active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your change
