US Utah-400, Setup And Operation, Page: 56 / 157

Hardware Installation
2-24
Hardware Installation
Hardware Checkout
Use the following flow chart to check out your Utah-400 System. Note the following important
points:
•
For the Video and Audio System columns may be switched numerically if encoding is not
required.
•
For the System Control column, the SC-4 Control system may require some configuration
in order to perform all functions.
Installation
Power
System
Video
System
Audio
System
Control
System
Install all frames
in the equipment
racks.
Interconnect all
cables.
Install all
Control Panels
and connect
them to the
controller.
Remove the
front panel from
each chassis.
Apply power to
each chassis.
Check that the
power light is
illuminated on
all Power
Supplies.
Check that no
alarms are
active.
Re-install all
front panels.
Monitor 1 output
switch between 2
inputs and verify
that the switch
occurs in the
Vertical Interval.
Sequentially
route all inputs
to one output (L
& R), then verify
that all inputs
are functional.
Route each
input to a single
output in
sequence.
Route a single
input to all
outputs.
Route a
different input to
each output.
Verify that the
Monitor Matrix
output is correct
for each output
signal.
From a single
control panel,
perform an ALL
LEVEL TAKE.
Sequentially route
one input to all
outputs (left and
right channels),
then verify each
output.
Route different
inputs to each
output.
Verify that the
Monitor Matrix
output is correct
for each output
signal.
Confirm that all
levels have
switched
correctly.
From a single
control panel,
perform a
BREAKAWAY
TAKE.
Confirm that all
levels have
switched
correctly.
Perform a TAKE
from each
control panel.
Checkout
Complete
*
* Red LEDs on the power supply