US Utah-400, Setup And Operation, Page: 151 / 157

144x144 Router
C-3
Installation of the AES Breakout Panel
1.
Install the BOP at the desired location on the rack frame. (Within three feet of the Utah-
400 Digital Audio Backplane.)
2.
Install the D/D 26 pin cables from the Utah-400 input or output 00 - 07 to the BOP
backplane input or output 00 - 07. Continue in the same manner for each input or out-
put for the remaining eight blocks on the breakout panel.
3.
Unpack the Field Wiring Kit and connect the required sources or destinations to each
of the tension clamp connectors. Refer to Figure D-2, on the following page for wiring
each tension clamp connector.
FIGURE C-1.
Wire Prep
1.
Insert the small screwdriver into the rectangular holes to release the wire clamp.
2.
Insert the wire into the round hold above or below the rectangular slot.
3.
While holding the wire in the hole, pull out the screwdriver (inserted in Step 1).
4.
Tug on the inserted wire to verify that it is properly clamped.
5.
Repeat for the entire connector.