US Utah-400, Setup And Operation, Page: 20 / 157

Introduction
1-2
Introduction
•
Appendix A
"Specifications" lists all system specifications, including Audio, Video, physical, power, and
regulatory.
•
Appendix B
“The Debug Port” contains information regarding the current Utah 400 firmware, along with
setup and use of the system Debug Cable.
•
Appendix C
“The Utah 400 Digital Audio Breakout Panel” applies to the installation and operation of the
AES Digital Audio Break Out Panel, a component designed to simplify the installation of the
Utah-400 Balanced Digital Audio Routing System.
Conventions
The following conventions are used throughout this guide:
•
Connectors and terminators will be indicated by bold, upper case text in Arial Black font.
For example:
• Connect the MX-Bus to J-1
•
Operator Actions will be indicated in Helvetica Bold where a board is inserted, removed
and/or an action is required in the Troubleshooting or configuration sections of this manual.
There will usually be a graphic to accompany the instruction(s). For example:
• Insert the expansion Input board in slot 6.
• Switch the suspected bad input to a known good input to verify output "X".
•
The use of bullets indicates a random order of operation or to draw the readers attention to
specific items.
1.
The use of numbers in specific operations or lists indicates a " recommended order of
operation " to perform specific tasks. Bulleted items may be below numbered items to
highlight tasks or indicate the operation(s) may be performed at random.