US Utah-400, Setup And Operation, Page: 42 / 157

Hardware Installation
2-10
Hardware Installation
2.
Remove the front cover from the Utah-400.
3.
Pull the Crosspoint slightly out of the router using the board ejectors located on the left
and right hand sides of the board. (The crosspoint board does not have to be removed
from the chassis to change configuration.)
4.
On the Crosspoint Board, at the midplane, locate the Configuration Dipswitch. See the
following illustration.
FIGURE 2-8.
Crosspoint Carrier Board Dipswitch Location
5.
There are two eight-position dipswitches on the Crosspoint Carrier Board. The Level
Dipswitch is located toward the front of the board; the Offset Dipswitch is located just
behind the Level dipswitch. See the following figure.
6.
Reference Table 2-1 to set the Level dipswitches and Table 2-2 to determine which
switches must be changed for the Level desired.
7.
Reference Table 2-3 to set the Offset dipswitches per your requirements.
Crosspoint Carrier Board
Primary Control Board Redundant Control Board
Level and Offset Dipswitch Location
Alarm LED Indicators
Crosspoint Board - Looking at the Front