56K Softmodem
Command Reference
- 87
Default: 13 (carriage return).
Base Unit: ASCII.
S4—Line Feed Character (User-Defined)
Use this register to set the ASCII value used as the line feed character. The 56K
Softmodem uses a line feed character in command mode when it responding to
the computer.
Note
: This register value is not stored with the &W command.
Range: 0—127.
Default: 10 (line feed).
Base Unit: ASCII.
S5—Back Space Character (User-Defined)
S5 sets the character recognized as a backspace. (Pertains to asynchronous
operation only.) The modem will not recognize the backspace character if it is set
to a value that is greater than 32 ASCII. This character can be used to edit a
command line. When the echo command is enabled, the 56K Softmodem echoes
back to the local DTE the backspace character, an ASCII space character, and a
second backspace character. Therefore, a total of three characters are
transmitted each time the modem processes a backspace character.
Note
: This register value is not stored with the
&W
command.
Range: 0—255.
Default: 8 (backspace).
Base Unit: ASCII.
S6—Time for Dial Tone
Use this register to set the length of time in seconds between the 56K
Softmodem’s off-hook event and dialing the first digit of the number. The 56K
Softmodem always pauses for a minimum of three seconds, even if the value of
S6 is less than three seconds. The wait for dial tone progress feature (W dial
modifier in the dial string) will override the value in register S6. This operation,
however, may be affected by some
X<value>
command options according to
country restrictions.
If bit seven of S53 is not set, this command sets the length of time (in seconds)
that the 56K Softmodem will wait for a dial tone before starting blind dialing.
Range: 3—255.
Default: 3.