56K Softmodem
Command Reference
- 36
Table 3-57: Valid <supp_delay> Values
+A8T=<sig-
nal>,<1st_message>,<2nd_message>,<sig_en>,<msg_en>,<supp_delay
>—Send V.8 bis
Table 3-58:
+A8T Extended Syntax Commands
+DR<value>—Data Compression Reporting
Use this command to enable or disable the compression report. If the
compression report is enabled, the
+DR:<type>
intermediate result code reports
the current DCE-DCE data compression type. It is issued after the error control
report (+ER) and before the final result code (e.g.,
CONNECT
).
Result codes:
OK
if <value> = 0, 1.
ERROR
if <value> does not equal 0, 1.
Table 3-59: +DR Data Compression Report Value
Value Meaning
0
No delay inserted (default).
1
Inserts a 1.5 s delay between transmitted V.8
bis
signal and the
subsequent V.8
bis
message.
Command Description
+A8T=<signal>,<1st_message>,
<2nd_message>,<sig_en>,<msg_en>,<supp_delay>
Sends a V.8
bis
command or message.
+A8T?
Displays the current configuration for sending a V.8
bis
message or command.
+A8T=?
Displays the supported configuration parameters.
Command Function
+DR=0
This command disables the compression report.
+DR=1
This command enables the compression report.
