63
DS1375-020E
11.21.4 ENABLING THE IPERCOM NETWORK
After creating an inbound routing rule it is necessary to check the Ipercom network configuration.
Select the following menu items: System
→
Advanced Configurations
→
System Definition
→
Network
→
IPerCom
Network.
If the integration with the Ipercom system requires the use of the switch Ref. 1375/701 follow the instructions
below:
1. Check that the “State” field is enabled.
2. In the field “Net Mode” select DHCP.
3. In the field “VLAN” leave the parameter value 6.
Press the key
to confirm the configuration.
If the integration with the Ipercom system does not require the use of the switch Ref. 1375/701, follow the
instructions below:
1. Verify that the field “State” is disabled.
2. Select the tab “WAN “ in the Network section.
— If there is no DHCP server (manual addressing) in the Ipercom system, set the “NET MODE” parameter to
“Static” mode and enter the IP address suggested by Ipercom.
You can view the IP address suggested by Ipercom through the Configurator. Select the topological node
where iPerTAlk is inserted and press the icon .
Summary of Contents for iPerTAlk 1375
Page 98: ...98 DS1375 020E...
Page 99: ...99 DS1375 020E...
