urmet domus iPerTAlk 1375, Installation And Configuration Manual

Page: 35 / 100

35 DS1375-020E
11.7.5 MANAGEMENT OF VIDEO CALL TO 1375/815 TELEPHONES
To be able to manage the video call with 1375/815 videophones it is necessary to configure some video
parameters.
Directly from the Videophone:
— Press on the “ Applications ” icon
— Press on “ Telephone settings ”
— Select the “ Video ” section
— Access the “ Other settings ” section and remove the tick from (leaving the other options unchanged):
• Hardware Endec Acceleration
• Hardware Decodec Acceleration
• Colour improvement
For the changes made to be effective, it is recommended to restart the 1375/815 videophone.
This configuration is required ONLY on 1375/815 devices that will receive or forward video calls to video door
phone devices.
11.7.6 CONVERSATION TIMEOUT SETTING
It is possible to set a timeout to stop conversations relevant to calls made from/to a call module.
Access the section System
→
Advanced Configuration
→
System Definition and press on System .
Edit the “ Doorphone conversation timeout (seconds) ” by setting the number of seconds relevant to the
maximum duration of the conversation.
Values higher than 15s are valid.
When the set timeout elapses, the conversation will automatically be interrupted by iPerTAlk.
11.7.7 DOOR OPENING COMMAND SENDING
It is possible to send the door opening commands to the external station. The commands can be sent during a
conversation or in standby, without being engaged in a conversation. The methods of use are described below.
11.7.7.1 SENDING OF DOOR OPENING COMMAND DURING A CONVERSATION
During a conversation (audio or video), regardless of how it has been initialised, it is always possible to send
the opening commands (dry contact or electric lock) from a telephone (IP or BCA) or videophone, as described
below.
Use th e telephone keys, during a conversation (audio or video), to dial:
1
→
to activate the electric lock;
2
→
to activate the dry contact.
11.7.7.2 SENDING DOOR OPENING COMMAND IN STANDBY (NOT DURING CONVERSATION)
If a conversation is not active, it is possible to send a door opening command to any call module connected to
iPerTAlk from any telephone (analogue or IP) or videophone part of the system, as described below:
Using the keys of the telephone enter:
*85*<extension paired to the external station>*<command>