urmet domus iPerTAlk 1375, Installation And Configuration Manual

Page: 46 / 100

46 DS1375-020E
3. In the “ Type ” field, select the “ Static ” parameter to configure the IP address of the camera in static mode.
4. In the “ IP Address ” field, set an IP address that is separate from that of the iPerTAlk devices but that is in the
same subnet.
5. After configuring the network parameters, set the camera streaming parameters.
6. Select the menu Network
→
Video Streaming to access the configuration page for the streaming parameters.
7. Select the streaming profile you want to configure: Main Stream, Sub Stream or Mobile Stream.
It is recommended to use the SubStream profile so as not to vary the resolution levels of profiles used for
other purposes.
8. In the “Resolution” parameter, set the desired resolution (maximum 1280 x 720).
ATTENTION! The maximum supported video resolution is 1280x720. If a video door phone Ref. 1375/825
is installed in the system, the maximum video resolution supported is 640x480.
9. In the “ FPS ” parameter set a minimum value of at least “10”.
10. In the “ Video Code Type ” parameter set the value to “H.264”.
11. Press the “ Save ” key to save the settings made.
After configuring the camera parameters, it is possible to acquire the camera in the iPerTAlk system.