41
DS1375-020E
To configure the access control it is necessary to access the menu
Multimedia
→
Access Control.
Once the
Interface has been accessed, click on the button
to create a new access code.
Configure the required parameters as described below:
Status:
select whether you want to enable/disable the new access code immediately after its creation.
Code:
enter the desired accessed code. Only numerical values are permitted (minimum 4 and maximum 8 digits).
Period (From – To):
enter the time range within which the code will be valid.
Relays:
select the actuators associated with the relevant entered code. It is possible to associate several
devices/actuators with the same code.
The code can be used to activate actuators of the external station where the code is entered.
Click on
to make the new configuration operative.
After its creation, it is possible to change or delete the new code at any time by clicking on the relevant action
buttons
.
On ELEKTA devices, the code can be entered both in access mode (key button) or in activation mode
(0x… sequence).
11.11 IP CAMERAS
The service requires the activation of a licence for
Generic video extensions Ref. 1375/340
.
Licences Ref. 1375/340 can be combined.
The following service allows displaying the video streaming of an IP camera, properly configured in iPerTAlk
system, using a videophone.
The IP cameras that can be used for this function must have the following features:
ONVIF compatibility: required for auto-discovery in the local network with respect to the iPerTAlk system.
RTSP: protocol for managing video streaming from the camera to iPerTAlk
H.264 video streaming coding.
Summary of Contents for iPerTAlk 1375
Page 98: ...98 DS1375 020E...
Page 99: ...99 DS1375 020E...
