Unipulse F805AT-BC, Operation Manual

Page: 27 / 202

3.SCREEN LAYOUTS AND SETTINGS
12
Status display
Lock
This lamp turns on when settings are locked:
・
LOCK (hard) is ON: is displayed in reversed red.
・
LOCK (soft) is ON: is displayed in reversed orange.
LOCK (hard) has the priority over LOCK (soft)
Run/NOV.RAM/DZ Warning/Flow Setting Over/Flow Setting Under
is displayed in reversed light blue while TOTAL measurement is being
performed.
is displayed in reversed light blue while the system is writing information to
NOV.RAM. Do not turn off power while is being displayed: this may results in
lost data.
・
is displayed in reversed red when abnormal zero occurs, that is, [DIGITAL
ZERO] operation is done while the total weight is in excess of the value specified in
[DZ REGUALTION VALUE].
・
s displayed in reversed red when flow setting over occurs, that is, the relation
below holds (only while RUNNING):
Feed Rate > Target Value + Fault Detect Value
・
is displayed in reversed red when flow setting under occurs, that is, the
relation below holds (only while RUNNING):
Feed Rate < Target Value - Fault Detect Value
Display priority of the alarms is as follows:
＞ ＞
,
＞
Upper/Lower limit, loading state
This item displays upper/lower limit, or loading state.
・
is displayed (in reversed red while RUNNING) when load ratio or feed ratio
exceeds its upper limit.
・
is displayed (in reversed light blue while RUNNING) when load ratio or feed
ratio falls below its lower limit.
・
is displayed when neither of the two states described above apply (in
reversed green while RUNNING). is displayed when [ALARM MODE] is
set to COMPARISON OFF.
・
is displayed (in reversed red while RUNNING) when Load Ratio [%] is
lower than Dead Band Load Ratio [%].
Loading state has higher display priority than upper/lower limit.
LOCK
LOCK
RUN
NOV
NOV
ZALM
OVER
UNDER
NOV ZALM OVER UNDER RUN
HI
LO
GO
OFF
NZ