7.CONTROL SIGNAL (External I/O Connector)
102
7-5-9. Running
This output is ON while the system is operating (measuring).
7-5-10. NZ
This output turns ON (only while RUNNING) when DEAD BAND LOAD RATIO [%]
is greater than LOAD RATIO [%]
7-5-11. Total final over
This output turns ON (only while RUNNING) when Total is greater than the set value
of Total Final. Note that “COMPARISON OFF” in [ALARM MODE] suppresses this
alarm.
7-5-12. Zero error measuring
This output turns ON while zero point auto adjustment is being carried out.
7-5-13. Zero error measure OK
This output turns ON for one second when zero measurement normally ends and the
zero error point data is updated. It does not turn on if zero measure failed.
7-5-14. Zero error measure NG
This output turns ON for one second when zero measurement failed or aborted. Zero
error point date will not be updated.
Summary of Contents for F805AT-BC
Page 1: ...F805AT BC BELT SCALE CONTROLLER 15 Feb 2019 Rev 1 03 OPERATION MANUAL...
Page 15: ...CONTENTS XIV M E M O...
Page 202: ......
